If it does not, please follow the setup steps to finish the driver installation. Figure About 3. Because the Adapter gets its power from the host, there is no external power supply. Operation is subject to the following two conditions: This field has a maximum limit of 32 characters. Wi-Fi – A trade name for the
|Date Added:||18 October 2004|
|File Size:||9.13 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The Profile screen provides tools to: The default tl-3221g is Auto Switch access point modewhich allows both short and long headers in the Default Gateway – The default gateway of the wireless network.
Even if one or more bits in the chip are damaged during transmission, statistical techniques tl-321v in the receiver can recover the original data without the need for retransmission. Turn off RF – The wireless radio of this adapter can be enabled or disabled.
The utility will establish a connection with this AP by configured profile.
TP-Link TL-WN321G (696726321002) Wireless Adapter
Our drivers have been tested thoroughly, and are able to work with the operating system. However, to an intended receiver i.
Click the Profile tab of the utility and click the Add button on the screen that appears. Please select YES to continue installation. If you want to use Windows XP to configure wireless network settings, you should exit the utility.
Utility Version – The version of this utility. This bit pattern is called a chip or chipping code.
This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. If the icon still does not appear, the driver or utility may be installed incorrectly or the adapter is unplugged, please try again.
Click Next to continue the Installation.
TP-Link TL-WNG 54Mbps Wireless USB Adapter TL-WNG B&H
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Add a Profile Delete a profile Edit a profile Activate a profile Figure Profile Tab To create a new profile, click the Add button on the Profile tab, the Profile configuration screen will appear shown in figure Increase the separation between the equipment and receiver.
Infrastructure Network – An infrastructure network is a group of computers or other devices, each with a wireless adapter, connected as an Click Browse to change the destination location for the software in figure Its auto-sensing capability allows high packet transfer up to 54Mbps for maximum throughput, or dynamic range shifting to lower speeds due to distance or operating limitations in an environment with a lot of electromagnetic interference.
Signal Strength – Shows the strength of the signal. Click Activate on the Tl-321v screen. However, there is no guarantee that interference will not occur in a particular installation.
Channel — Shows the current channel in use. To an gl-321g receiver, DSSS appears as low power wideband noise and is rejected ignored by most narrowband receivers. EN V.
WN321G 54 Mbps Wireless USB Adapter User Manual TL-WN321G 1.0 TP-Link Technologies Co., Ltd.
If you have plugged it into you PC already, please un-plug it and plug it back in. Edit the Configuration tab Profile Name – Identifies the configuration profile. Do not forget to click tl-32g Activate button when you create a tl-312g profile for connection. Display current status information Edit and add configured profiles Display current diagnostics information The section below introduces these above capabilities.
You can enter 26 hexadecimal digits any combination ofa-f, A-F or 13 ASCII characters for bit also called bits encryption.
TP-Link TL-WNG () Wireless Adapter | eBay
This field determines which operating frequency will be used. Driver Version – The version of the wireless network adapter driver. You can turn the wireless radio off by selecting the check-box.